Pen and Ink

Stippling with Pen and Ink: Technique and Practice Exercises

Learn stippling with pen and ink: the right pens and paper, how to place dots for smooth value, and practice exercises from value scales to a shaded sphere.

On this page
  1. What stippling is
  2. Pens and paper for stippling
  3. How to make a good stipple dot
  4. Building value with dots
  5. Stippling exercises
  6. Edges without outlines
  7. Common mistakes and fixes
  8. Stippling vs pointillism
  9. How long does stippling take?

What stippling is

Stippling is a way of creating tone using dots instead of lines. Sparse dots read as a light grey, and densely packed dots read as dark. Your eye blends them into smooth tones when you look from a normal viewing distance.

Stippling is slow, but it gives very soft, controlled gradients and a distinctive look. It’s long been used in scientific and natural history illustration, because it reproduces well and describes form without strong directional marks. Stipple techniques also appear in engraving and printmaking going back several centuries.

Pens and paper for stippling

Pens. Any pen that makes a clean dot works:

  • Pigment fineliners such as the Sakura Pigma Micron, Copic Multiliner or Staedtler Pigment Liner are the most common choice. Sizes around 0.1–0.3 mm give fine, delicate tone. Larger sizes cover ground faster. The trade-off is that tapping wears fibre tips down, so use a light touch. Some refillable fineliners have replaceable nibs.
  • Technical pens such as the Rotring Isograph or Rapidograph have metal tips that cope well with repeated vertical tapping, but they need regular cleaning.
  • Dip pens can stipple too, though dot size varies more.

You don’t need several sizes. One pen can create a full value range through spacing alone. Using two or three sizes, with bigger dots for darker areas, does speed things up. For more on choosing pens, see our guide to pens for pen and ink drawing.

Paper. Use a smooth surface: bristol board, hot-pressed watercolour paper, or a smooth heavyweight drawing paper. Textured paper makes ragged dots and wears pens faster. See the best paper for pen and ink drawing.

Also useful: a pencil for light guidelines, a soft eraser, and a scrap sheet under your hand.

How to make a good stipple dot

  1. Hold the pen nearly upright. A low angle makes dots oval.
  2. Touch and lift straight up. Don’t drag. Dragging creates “tails” or commas.
  3. Use light, even pressure. Tapping hard damages fibre tips and makes uneven dots.
  4. Find a steady rhythm. Not too fast, or you’ll start leaving tails.
  5. Place dots randomly. Avoid lines, grids and rows, which the eye picks up immediately as patterns.

Building value with dots

You control value in three ways:

  • Spacing: closer dots look darker. This is the main tool.
  • Dot size: bigger dots, from a larger pen, look darker.
  • Layering: a second pass of dots over an area deepens it gradually.

Always work from light to dark. Put down a light, even layer across the whole area, then build the darks in successive passes. You can always add dots, but you can’t remove them.

Stippling exercises

Exercise 1: dot control

Fill a small square, about 3 cm, with evenly spaced dots, with no rows and no tails. Then fill another with dots twice as dense. Check both squares for tails and patterns.

Exercise 2: five-step value scale

Draw five boxes in a row:

  1. Leave the first white.
  2. Fill the second very sparsely.
  3. Make the third roughly a mid-grey.
  4. Make the fourth dense.
  5. Make the fifth so dense the dots nearly merge.

Squint at the result. Each step should look evenly darker than the last. Write the pen size under each box. This becomes your reference chart.

Exercise 3: smooth gradient strip

Draw a long rectangle and stipple a gradient from white at one end to near-black at the other, with no visible steps. This is the hardest of the basic exercises. The secret is to add dots gradually across the whole strip, increasing density toward the dark end with each pass.

Exercise 4: shaded sphere

Draw a circle in light pencil. Choose a light direction and mark a small highlight that you’ll leave white. Stipple the whole sphere lightly, except the highlight. Then build density toward the shadow side, leaving a slightly lighter band of reflected light near the bottom edge. Add a cast shadow underneath, darkest where the sphere touches the ground. Erase the pencil when the ink is dry.

Exercise 5: texture swatches

Stippling isn’t only for smooth tone. Try small squares of:

  • Stone or concrete: random clusters, with a few larger dots.
  • Sand: very even, fine dots.
  • Fur: dots arranged loosely along the direction of hair growth.
  • Rust or moss: dense, irregular clumps.

For more texture ideas, see pen and ink textures.

Exercise 6: a simple object from life

Choose something with clear light and shadow, such as an egg, an apple or a mug, lit from one side. Make a light pencil outline. Find the darkest dark first. Squinting helps, and so does a greyscale photo of your setup. Then stipple from light to dark, stepping back often to judge the overall value.

Edges without outlines

Stippled drawings often look best without hard outlines. Instead:

  • Define an edge by contrast, placing dense dots against white paper.
  • Let light edges dissolve, with dots thinning out toward a lit edge.
  • If you do outline, stipple it. Concentrate dots along the contour rather than drawing a line.

Common mistakes and fixes

Problem Likely cause Fix
Dots have tails Dragging or working too fast Slow down and lift straight up
Visible rows or patterns Placing dots too regularly Scatter dots randomly, rotating the paper occasionally
Patchy, blotchy tone Uneven density between passes Work the whole area in light layers
Too dark too soon Starting with the darks Always build from light to dark
Pen tip flattened Pressing hard Use a lighter tap, or switch to a technical pen
Drawing looks flat Not enough value range Push the darkest darks further and keep highlights clean

Stippling vs pointillism

The two are related but different. Stippling typically uses a single colour of ink, usually black, to build tone. Pointillism is a painting technique associated with Georges Seurat and Paul Signac in the late 19th century. It uses dots of different paint colours that mix optically in the viewer’s eye.

How long does stippling take?

It depends on size and darkness. A small value scale might take 15–20 minutes, while detailed finished stippled drawings can take many hours. Break big pieces into sessions, and use bigger pens for large dark areas to save time. If you want tone faster, you could combine stippling with hatching, or try ink wash drawing, which builds tone with diluted ink instead of marks.

The complete guide to pen and ink

The Best Pens for Pen and Ink Drawing
Read the guide

Keep exploring

Guides from other topics

All topics →